Industrial tablet common problem

in everyday use, PLC controller inevitably encounter problems, often face PLC controller suddenly stuck even crash problem, is not convenient to use, so today we will introduce several reasons of tablet suddenly stuck if you later encountered similar problems can refer to this article, to solve problems of industrial tablets, but if we introduce the methods are not applicable, it is likely to be more serious problems, suggested to find out the professional repair.

their relationships: we all know that industry tablet running speed and the configuration of the tablet itself has a lot to do. The configuration, the better, the faster running speed. Configure the worse of course will be run slow. When we run software industrial tablet configuration can't keep up with, will crash. Solution: replace the better configuration or buy a configured industrial tablets.

system disk capacity is insufficient, I often see friends industrial tablet DianNaoXi TongPan less than 10 G, also often call their industrial tablet computer often freezes. In this case, crash is inevitable. Want to know the whole industrial system disk is afraid to do after computer systems and software to run. When space is not enough to program to run, of course, will be crashed. We should often tidy system disk, move the files to other disk. There is usually installed software to pretend other plate.

running program too much: industrial tablet running program, the more the amount of the higher industrial tablet computer memory. When more than half of memory used will often appear crash. This is inevitable. The most common phenomenon is crashed. Solution: reduce the running program or increase the memory.

desktop file too much: don't understand industrial tablet's friend often put the files and download software in industrial tablet computer desktop. Basic can see the whole desktop traying, anything you can't get to use. But the desktop file is stored in the system tray, can you? Finally lead to insufficient system disk crash. Solution: desktop file should save all the classification step to another drive, which can relieve system disk space, and find their own files also convenient.

another common problem: industrial tablet screen failure

generally has the following several ways:

a, is a system failure: industrial general reset the tablet computer system failure or change the system. In many cases, the hardware doesn't recognize under Windows system is caused because there is no right and power, this is a temporary problems during the equipment operation more, when we completely shut down and cut off power supply, reboot the system, equipment failure in general will be solved. So, when we meet with this kind of situation, can use the simple way to solve first tablet touch screen failure. A long press on the tablet power key, completely turn off the tablet system power supply, and then restart the tablet Windows.

2, restore the reset, the BIOS is invalid. If by the above methods are set invalid cases, only through the system restore, restore, or reset the tablet to solve the problem, even need to refresh the BIOS to solve it.

three, is a hardware failure: a hardware failure usually touch screen contact is bad, and the ribbon cable interface is loose. Can open the back cover, you can check the mainboard and screen link row line if you have any questions. If the beginning ability is not strong help can look for maintenance station.