How to reasonable installation and use of machine of decelerate of planet of

Reducer is a kind of common power convey institutions, are used in all kinds of mechanical transmission system. Reducer reducer is directly related to the installation and use of the running effect, to comply with the technical specifications and standards. How to reasonable installation and use of reducer, attention should be paid to the following matters. Before the installation note: 1, the machine before use in the face of the shaft for cleaning. And check whether installed shaft has a bruised, dirt, if any shall all be cleared away. 2, the use of the reducer is 0 ~ 40 ℃ temperature. 3, check and reducer coupling hole ( Or shaft) With the size is in line with the requirements, the hole of tolerance should be H7 ( Shaft tolerance for H6) 。 4, before use should be the highest level of congestion vent plug, ensure reduction during exhaust gas in the body. During the installation process of note: 1, the reducer in the installation, it is important to pay special attention to the transmission of the central axis of the, the error must not exceed reducer used in coupling with the compensation amount. Reducer in accordance with the requirements of, can obtain more ideal transmission effect and long service life. 2, the output of the reducer shaft when installing a driver, must pay attention to the soft operation, it is prohibited to use a hammer tools such as rough installation, it is best to use assembly fixture and internal threads for installation of end shaft to the strength of the bolt screw in the press into the speed reducer drive, in order to protect reducer internal parts will not be damaged. 3, reducer, fixed is very important, to ensure the smooth and strong, generally we reducer should be installed in a horizontal foundation or base, at the same time line should be able to rule out the oil tank and the cooling air circulation fluid. Fixed bad reducer, infrastructure is not reliable, can appear, vibration and so on phenomenon, also will make the bearings and gears from unnecessary harm 4, reducer, transmission connection, when necessary, should be equipped with protection device, such as a projection on connection or the use of gear, chain wheel drive, etc. , if the output bearing radial load is bigger, also should choose enhanced. 5, reducer can only be installed on the flat, shock absorption, torsional support structure. 6, in any case, are not allowed to use a hammer to pulley, coupling, small gear or sprocket and type on the output shaft, and that this might damage the bearing and shaft.